Dave - PA
Post-Delivery FeedbackApr 3, 2026
Purchased the Tipton Ultra Vise. VERY disappointed in the product. I spent over three decades in a product develop and manufacturing career...so I understand what poor manufacturing and lack of quality control looks like. The front and rear clamps that are supposed to adjust vertically were almost impossible to slide up and down. There was a mold defect in one half of the sliding bases that attach to the tubular frame. It was the same on both clamps and was interfering with the vertical clamps. After removing the excess plastic from the mold defect with a file, the clamps still would not slide up and down smoothly. Had to take a Dremel tool and remove all the mold flash from the sides of the vertical clamps. After spending almost an hour fixing the crapping molding defects, the vertical clamps now slide properly. Additionally, the knobs that tighten the ball-n-socket pads are super hard to turn. Again...either a poor design with too much interference, or poor molding quality. VERY disappointed in the quality of this product.